Altec Lansing FX6021 2.1 Speaker System

The average quality of computer speaker systems is improving. That’s not saying much. It couldn’t get much worse. It’s always been possible to connect a really good sound system to a PC – well, to any PC with sound hardware beyond the PC speaker , anyway. Since all PC sound cards have a normal unbalanced one-stereo-pair line level output, you can just plug ’em straight into a stereo, home theatre or PA system of arbitrary gruntiness, and you’re away. People don’t generally do that, though.

Altec Lansing 251 Speaker User Manual

These premium speakers sport some premium features, and a premium price. Are they worth the extra cash? Listen up, and read on for the full scoop. Apparently, the system uses 3 amplifier to power each of the 12 speakers and the subwoofer. The subwoofer is similar to the one found in the MX system: The design of these speakers is truly upscale, with an elegant silver-metallic finish that is sure to go with any decor.

How do you hook up altec lansing speakers to the computer You have to set your speakers first.\\Connect the cables between them, connect the subwoofer(if any)Connect the speakers to the power.\\Then conect the cable with the end green (pin male connector) to green hole in the.

Introduction We have been designing, building, and selling DIY speakers–using full-range drivers–for more than 20 years now. We are one of the largest manufacturers of these types of speakers anywhere in the world. For the first time, it’s possible for you to buy directly from a manufacturer. In this way, you get the most value for your money AND the best sound possible.

A lot of work goes into making a true ‘full-range’ speaker, one that approaches 20, cycles in the treble. It is necessary to fit powerful magnets to obtain these high frequencies.

Question regarding integrating Altec Laguna speakers with current 7.1 surround systems

The subwoofer is set up about three or four feet away from the computer to avoid magnetic interference problems with the monitor. I was getting no sound, so started looking through the maze of cords and found that somehow a cable seems to be missing. I have an extension cable coming out of the back of the computer where the sound is supposed to be connected but there is nothing connecting it to the subwoofer all the connections for the speaker system are on the back of the subwoofer.

While it seems a bit ridiculous to think the cable disappeared, the cables run over the cold air return and for the last few months, my elderly dog has been sleeping in this cubbyhole between the computer and the subwoofer, so I guess I’m blaming the dog for doing something with the cable.

The speakers connect easily to any computer — just plug them into a USB port and you’re ready to go. Thanks to Altec Lansing’s Audio Alignment technology, the system’s drivers, enclosure, and electronics are perfectly balanced, giving you the full, high-quality stereo sound your digital life demands.4/4.

I have a 19″ and a 17″ both have the dell sound bar underneath the screens purchased separately 1 is hooked up, but i would like to hook up both, any info on how i could do this with my mac pro model? Odly, they work just fine with that. Then i tried with my headphones from my iPhone – no sound at alle. The classic “bong” sound at startup, I know that is the result of a successful POST, but mine didn’t do one after the 1st startup. I had speakers plugged in to it when I started up the 2nd time, and no sound.

I unplugged the speakers, and I got the sound. Is that normal or do I need to contact Apple?

How to Hook Up Additional Speakers to a Bose Wave Radio

Four specially engineered full-range neodymium micro drivers with aluminum cones smoothly deliver a full spectrum of pure, distinct sound with unprecedented signal accuracy. To manage even this small amount of wiring the USB cord is made retractable, no need to wrap the cord around the speakers when carrying it around. The stands and speaker connecting cord is easily stowed in the provided carrying case.

On the back of the main speaker is a jack that you plug the cord into that then runs into the USB port on your notebook. To actually carry these lightweight speakers Altec provides a high-quality durable carrying case.

Jan 02,  · Hook the tv up to line 1 and the computer up to line 2, then hook the stereo receiver output to the input of your subwoofer. Then shift the receiver from line 1 to line 2 (as easy as pressing a button on the front of the receiver) to hear either one through your speakers.

I would suggest you to check the following settings. Check the connection to the wall outlet. Most speakers and subwoofers have a light showing there is power when they are turned on. Check to see if your subwoofer has a fuse, and if it does check the fuse to make sure it is ok. One or two of the speakers do not work 1. Check to make sure they are getting power 2. Check the connections from the back of the computer to the speakers. The speakers should connect to the line-out jack on the back of the computer.

Check the cables and make sure they are firmly connected between line-out plug on the back of the computer and the speakers. If you have powered speakers and connect them to the “speaker out” connector you can get Crackling. Also, check the volume control in Windows and make sure that it is not set more than half-way Radio Feedback 1.

Move the speakers in a different location or rotate them to see if it helps. Buy cables that have better shielding. Make sure you are using the Line-out plug on the back of the computer.

Windows 7 , Toshiba laptop, adding external speakers

Powered by USB connection or wall socket; look fabulous; durable design; very portable; clean sound; subwoofer-out port; built-in USB microphone. Not much audio punch, even on wall-socket power; volume drops substantially on USB power; big price tag; subwoofer should have come standard with the package rather than selling as an add-on.

They look great, they sound good, but they’ll have a much bigger impact on your wallet than your ears. I’ve long been a fan of Altec Lansing’s computer speakers, and the XT2 is the first set of portable speakers I’ve tried from the company. Is a portable set of speakers worth that kind of coin? Story continues below advertisement My initial reaction was ‘no way.

Solved how to connect altec lansing fx to my samsung uhd 55″ smart tv bluray sound only tv speakers Forum; Solved how to hook up an old harman kardon pm amplifier and tuner to new.

In my case, I also have the added burden that two of my main contributors are or were speaker manufacturers, some of whose products you will see as References below. Other associates are distributors of speaker lines. Accordingly, I made the only decision I could: All the choices in this category are mine alone. What I say to those who question my objectivity is; please closely read the rest of the References first to see my consistency and sensitivities, before making judgements on the few choices you may be understandingly skeptical about.

Any final and true judgement concerning these or any specific components requires a personal listening session with them. If this list inspires such an event, it has been a success, no matter what the ultimate result. Behind the Curve This is the component category in which I believe that I am most “behind the curve”. While I am very confident that all the speakers that are included deserve to be there, I am just as confident that there are at least an equal number of others that are missing.

I have heard some of the “missing”, but I haven’t yet made the in-depth evaluations and comparisons that are a requirement for their inclusion. Alternate Priorities Important Distinction:

Browsing interrupted

It was working and in transitioning it from my office to my home it stopped. The light would come on, but no sound. I checked the green hook-up wire that connected the source computer or iPod with the Altec speakers with an ohm meter. The cord was ok, having continuity were it should.

of results for “altec lansing bluetooth speakers” Showing selected results. Bluetooth speaker with an impressive wireless range plays music from up Altec Lansing IMT Sonic Boom 2 Ultimate Waterproof Bluetooth Speaker (Black) through Altec Lansing’s Connect.

Had a Dell Dimension hooked up to some Altec Lancing speakers. This Site Might Help You. Connecting Speaker System to Laptop. This Altec Lansing speaker Please carefully read this User Guide for instructions on setting up and using your inMotion Max speaker 1 Connect the speaker. Bluetooth technology allows users to connect different devices to their speakers wirelessly when the device and speaker Setting Up Altec Lansing Bluetooth Speakers.

The speakers from their stands by gently pulling the speaker up. View and Download Altec Lansing user manual online. Your computer experience is made up by three things: The subwoofer has a separate volume control for. Add powerful sound to your home theatre with the Polk Audio RM 6piece speaker system. How do i hook up speakers correctly to my computer? Speakers are, of course, the most difficult of all components to evaluate, even in the best of circumstances.

Altec Lansing XT1 Portable Speakers Review (pics, specs)

Altec Lansing Select multimedia speaker system Review date: The Quest for Bass is, generally, a futile one, if you’re shopping for computer speakers. Computer speaker systems without subwoofers aren’t in the race at all; computer speaker systems with subwoofers almost always don’t have a big enough one.

How do i hook up two altec lansing speakers and Depending on the sound card installed in your system, integrated into the motherboard or not, you may need a “Y” splitter adapter. Typically, the subwoofer has a black plug while the regular speakers have a green plug.

Share on Facebook Bose Wave radios are designed to be stand-alone stereos that deliver superior sound for a compact audio component. The built-in amplifier is designed to power the pair of stereo speakers inside the Bose Wave, so connecting additional speakers requires an external power source to drive them. The easiest way to do this is with a pair of self-powered speakers, such as the kind designed for use with computer systems.

Desktop speakers won’t make power demands on the Bose and will, instead, enhance the radio’s sound quality. Step Connect the audio cable from the left external speaker to the “Audio OUT” jack on the back of the right speaker using the mini-plug on the end of the cable. Step Connect the “Audio IN” cable on the right speaker to the headphones jack on the back of the Bose Wave radio, inserting the mini-plug on the end of the speaker cable into the jack until it clicks into place.

Step Attach the DC power cord plug to the back of the right-channel external speaker and plug the transformer on the other end into a wall outlet. Step Switch on the Bose Wave and set to the desired volume, then turn on the self-powered external speakers, typically by turning the on-off knob clockwise, and adjust the external speakers to the desired volume.

How to Hook Speakers to a TV

Then came the most unusual reason I’ve heard to date; He replied that Altec Lansing sounded as if they were made in China and bought the Cambridge instead! I didn’t know that some people had such different opinions about Altec Lansing, which is one of the leading brands for PC speakers just like how Diamond is for the video-card business. They have large partners such as Dell where they sell large quantities of OEM speaker-sets and even make a few tailored models for them.

I’m sure that most of you at some point of time have come across Altec Lansing speakers in action. Some of us may argue that the Midiland Diamond , Cambridge or Boss offerings are better.

Introduction: Altec Lansing ADA User’s Guide System Overview. The ADA is a THX Certified, high power multimedia speaker system designed specifically for superior audio performance and seamless integration to your computer system.

I’m unsure of why this is so as you can buy the retail top-of-the-line Altec Lansing ACS with subwoofer. But don’t be disappointed, read on! They still seem large next to 17″ monitors. Oh yes, since these are magnetically shielded speakers, you can place them really close to the monitors. But as with all speakers, they do cause some jumping when placed next to a Trinitron monitor, so beware. You will not see the jumping if you place the speakers some distance away from the Trinitron monitor.

Here are the physical dimensions: The right-speaker also has 4 controls in front: Volume, Center, Surround, and Subwoofer volume controls. The surround speaker switch gives you an option of whether you would like the side speakers to be activated to give a surround sound effect. All 3 have Dolby Digital Pro-Logic circuitry built-in. The Bass is so good on these speakers that I wonder what would it sound like if there was a subwoofer attached.

Generally if you like Bass at a moderate to above average, the bass provided by these 2 speakers are sufficient, unless you’re an audiophile or likes heavy Bass, then it’s advisable to attach a subwoofer.

How to connect Altec Lancing mini speaker to device plus test with water


Hello! Would you like find a sex partner? Nothing is more simple! Click here, registration is free!